Texas Instruments TS3USB30EDGSR TS3USB30EDGSR Analog Multiplexer / Demultiplexer 1:2 2 Circuits 10 ohm 1 µA 3V to 4.3V VSSOP-10

The TS3USB30EDGSR is a 1:2 Mux/Demux Switch with single Enable and ESD protection specially designed for the switching of high-speed USB 2.0 signals in handset and consumer applications, such as cell phones, digital cameras and notebooks with hubs or controllers with limited USB I/Os. The wide bandwidth (900MHz) of this switch allows signals to pass with minimum edge and phase distortion. The device multiplexes differential outputs from an USB host device to one of two corresponding outputs. The switch is bidirectional and offers little or no attenuation of the high-speed signals at the outputs. It is designed for low bit-to-bit skew and high channel-to-channel noise isolation and is compatible with various standards such as high-speed USB 2.0 (480Mbps).

• Green product and no Sb/Br
• D+/D- pins tolerate up to 5.25V
• 1.8V Compatible control-pin inputs
• IOFF supports partial power-down-mode operation
• 0.35R Typical Î�RON
• 7.5pF Typical Cio(on)
• Low power consumption (1µA maximum)
• 900MHz Typical bandwidth (-3dB)
• Latch-up performance exceeds 100mA per JESD 78, class II

Applications

Signal Processing, Portable Devices, Consumer Electronics, Industrial

Warnings This device has limited built-in ESD protection, leads should be shorted together or the device placed in conductive foam during storage or handling to prevent electrostatic damage to the MOS gates.

Other details

Brand	TEXAS INSTRUMENTS
Part Number	TS3USB30EDGSR
Quantity	Each (Supplied on Cut Tape)

All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them. Image is for illustrative purposes only. Please refer to product description.