Texas Instruments SN74LVT16245BDGGR Transceiver 74LVT16245 2.7 V to 3.6 TSSOP-48

The SN74LVT16245BDGGR is a 16-bit Bus Transceiver with 3-state outputs. The non-inverting 3-state transceiver is designed for low-voltage (3.3V) VCC operation, but with the capability to provide a TTL interface to a 5V system environment. It is also designed for asynchronous communication between two data buses. The logic levels of the direction-control (DIR) input and the output-enable (OE) input activate either the B-port outputs or the A-port outputs or place both output ports into the high-impedance mode. The device transmits data from the A bus to the B bus when the B-port outputs are activated and from the B bus to the A bus when the A-port outputs are activated. When VCC is between 0 and 1.5V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 1.5V, OE should be tied to VCC through a pull-up resistor and the minimum value of the resistor is determined by the current-sinking capability of the driver.

• Supports mixed-mode signal operation
• IOFF and power-up 3-state support hot insertion
• Distributed VCC and GND pins minimize high-speed switching noise
• Flow-through architecture optimizes PCB layout
• Latch-up performance exceeds 100mA per JESD 78, class II
• State-of-the-art advanced BiCMOS technology design for 3.3V operation/low static-power dissipation
• <0.8V at VCC = 3.3V, TA = 25°C VOLP (output ground bounce)
• Green product and no Sb/Br

Applications

Industrial, Automation & Process Control, Signal Processing, Communications & Networking

Other details

Brand	TEXAS INSTRUMENTS
Part Number	SN74LVT16245BDGGR
Quantity	Each (Supplied on Cut Tape)

All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them. Image is for illustrative purposes only. Please refer to product description.