Texas Instruments SN74LVC1T45MDCKREP SN74LVC1T45MDCKREP Transceiver 74LVC1T245 1.65 V to 5.5 SC-70-6

The SN74LVC1T45MDCKREP is an enhanced single-bit dual-supply Bus/Configurable Voltage Transceiver with 3-state outputs. This non-inverting bus transceiver uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.65 to 5.5V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.65 to 5.5V. This allows for universal low-voltage bidirectional translation between any of the 1.8/2.5/3.3/5V voltage nodes. It is designed for asynchronous communication between two data buses. The logic levels of the direction-control (DIR) input activate either the B-port outputs or the A-port outputs. The device transmits data from the A bus to the B bus when the B-port outputs are activated and from the B bus to the A bus when the A-port outputs are activated. The input circuitry on both A and B ports always is active and must have a logic HIGH or LOW level applied to prevent excess ICC and ICCZ.

• VCC Isolation - If either VCC input Is at GND, both ports are in the high-impedance state
• DIR Input circuit referenced to VCCA
• IOFF Supports partial-power-down mode operation
• Controlled baseline
• One assembly/test site
• One fabrication site
• Extended life cycle
• Latch-up performance exceeds 100mA per JESD 78, class II
• 4µA ICC Low power consumption
• ±24mA Output drive at 3.3V
• Green product and no Sb/Br

Applications

Aerospace, Defence, Military, Avionics, Medical

Other details

Brand	TEXAS INSTRUMENTS
Part Number	SN74LVC1T45MDCKREP
Quantity	Each (Supplied on Cut Tape)

All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them. Image is for illustrative purposes only. Please refer to product description.