NXP LPC2129FBD64/0115 ARM MCU LPC Family LPC2000 Series Microcontrollers ARM7TDMI 32 bit 60 MHz 256 KB 64 Pins

The LPC2129FBD64/01 is a 16/32-bit Microcontroller based on ARM7TDMI-S CPU with real-time emulation and embedded trace support. A 128-bit wide memory interface and an unique accelerator architecture enable 32-bit code execution at maximum clock rate. For critical code size applications, the alternative 16-bit Thumb mode reduces code by more than 30 % with minimal performance penalty. The device incorporates 256kB internal flash, 16kB internal RAM, 4-channel 10-bit A/D converter, various 32-bit timers, PWM channels and 46 general-purpose I/O pins.

• In-system programming (ISP) and In-application programming (IAP)
• EmbeddedICE-RT interface enables breakpoints and watch points
• Embedded trace macrocell enables non-intrusive high speed real-time tracing of instruction execution
• Multiple serial interfaces including two UARTs (16C550), fast I2C-bus (400 Kbit/s) and two SPIs
• 60MHz Maximum CPU clock available from programmable on-chip phase-locked loop
• Vectored interrupt controller with configurable priorities and vector addresses
• Up to forty-six 5V tolerant general purpose I/O pins
• On-chip crystal oscillator with an operating range of 1MHz to 30MHz
• Two low power modes, Idle and power-down
• Processor wake-up from power-down mode via external interrupt
• Individual enable/disable of peripheral functions for power optimization
• Fast GPIO ports enable port pin toggling up to 3.5 times faster than the original device
• Dedicated result registers for ADC reduce interrupt overhead
• The ADC pads are 5V tolerant when configured for digital I/O function
• UART0/1 include fractional baud rate generator, auto-bauding capabilities & handshake flow-control
• Buffered SSP serial controller supporting SPI, 4-wire SSI and microwire formats
• SPI programmable data length and master mode enhancement
• Diversified code read protection (CRP)
• General purpose timers can operate as external event counters

Applications

Automation & Process Control, Medical, Communications & Networking, Embedded Design & Development, Industrial

Warnings Market demand for this product has caused an extension in leadtimes. Delivery dates may fluctuate. Product exempt from discounts.

Other details

Brand	NXP
Part Number	LPC2129FBD64/01,15
Quantity	Each
Technical Data Sheet EN
CAD CadSoft_EAGLE EN

All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them. Image is for illustrative purposes only. Please refer to product description.