uIO STICK is an interface device for controlling Infineon boards/kits during run time. It enables the connection between the evaluation board and USB for SPI programming and monitoring by using the Config Wizard software which can be downloaded via the Infineon Toolbox. Plugs into the evaluation board via a standard 16-pin connector and allows easy interface to the microcontroller via USB for SPI, CAN, LIN communication etc. It also implements GPIO ports, PWM generation up to 20KHz and an analogue measurement interface (ADC). The uIO-Stick provides two exclusive functions, one is Infineon embedded power BSL support and other is run time control - programming and monitoring.
- Communication with the connected device via LIN, SPI and UART
- Four GPIOs, PWM signal generation up to 20KHz
- Measurement of analogue voltages up to 20V
- Read and keep functionality to detect reset of the connected device
- USB HID device, so no additional driver installation required
- uIO Stick can power a target device
- Connected device can also be powered by external power supply for higher current
- 3 on-board status LEDs
- Additional BSL Updater GUI for BSL communication with embedded power devices
Warnings Market demand for this product has caused an extension in leadtimes. Delivery dates may fluctuate. Product exempt from discounts.
Other details
| Brand |
INFINEON |
| Part Number |
UIOSTICKTOBO1 |
| Quantity |
Each |
| Operating Instructions EN |
 |
All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them. Image is for illustrative purposes only. Please refer to product description.
