Comprehensive kit which allows you to measure the electrical conductivity of aqueous solutions and evaluate water quality. With a plug-and-play design, intuitive software library and support for 3.3V/5V microcontrollers (such as Arduino) it can be a simple and effective measuring solution. The software library uses a two-point calibration method, temperature compensation algorithm and can automatically identify standard buffer solution.
- 3V-5V Wide voltage input range and support for both 5V and 3.3V control boards
- Hardware based filter for the output signal reduces jitter
- Reduced polarisation to improve precision and prolong probe lifespan
- Plug and play Gravity 3-pin interface and BNC probe connector for convenience, no soldering required
- Board output voltage: 0-3.4V
- Measurement Accuracy: ±5%
- Board size: 42x32mm
- Laboratory Grade probe
- Probe cell constant: 1.0
- Probe Detection Range: 0-20ms/cm
- Recommended Detection Range: 1-15ms/cm
- Temperature Range: 0-40°C
- Probe Life: Approx. >0.5 year (depending on frequency of use)
- Probe cable length: 1m
Applications
Embedded Design & Development, Electronics Design, IoT (Internet of Things), Hobby & Education
Contents
Conversion board, conductivity probe (K=1), 2x 1413us buffer solution, 2x 12.88ms buffer solution, analogue sensor cable, 2x waterproof gaskets, BNC cap, screws and standoffs
Footnotes Note: The probe is laboratory-grade; it is not designed for long periods of immersion and should be cleaned after each use.
Product details
| Accessory Type |
Analog Electrical Conductivity Sensor /Meter V2 |
| For Use With |
Arduino Development Boards |
| Product Range |
Gravity Series |
Other details
| Brand |
DFROBOT |
| Part Number |
DFR0300 |
| Quantity |
Each |
| Technical Data Sheet EN |
 |
All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them. Image is for illustrative purposes only. Please refer to product description.
